Run more parts, cut rework, and keep your machines performing at their best-every shift.
What Are Fixtures & Tooling?
Fixtures and tooling are what make machines productive. Fixtures hold part steady during machining. Tooling is what actually cuts or shapes the part. When these aren’t designed for your specific job, you lose time, quality, and output.
At m2nxt, we design both from scratch, so your setups are faster, cuts are accurate, and your output stays consistent, shift after shift.
We build fixtures and tooling for any brand VMCs, HMCs, and turning centers, each designed to match parts requirement, machines, and how your shop runs. So, setups are smoother, cuts are accurate, and every cycle delivers exactly what it should.
Brand Agnostics process engineering with or without tooling but always with any of following
Trusted by manufacturers across sectors where precision, uptime, and traceability matter most.
Automobile
Energy
General Engineering
Earth Moving and Tractors
Design Before You Build – Automotive Engine Line Simulation
No More Setup Failures – CNC Machine Virtual Testing
Balance Before Production – EV Battery Assembly Optimization
light - Ready Production Planning – Aerospace Component Line
If your setups take too long or part quality varies, custom fixtures can save time and improve consistency—especially for CNC shops in medium to high volume production.
Process Engineering, Physical and smart automation all under single roof. Gets synergized and get prefect tailor made solution to your requirement.
Absolutely. We design fixtures and tools to fit your current machines of any brand.
Yes. We provide on-site support for fixture setup and tooling trials across globe, so you're up and running without delays.
Yes, absolutely. We build solutions for both high-volume production and low-volume or prototype machining, ideal for job shops and R&D units.
With m2nxt, you don’t just monitor - you understand, Optimized, and excel.